0

Out of 0 Ratings

Owner's of the PYLE Audio PDAs & Smartphones IKON RUGGED gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 406
 
Chapter 7: Peripheral Devices & Accessories
Troubleshooting
262 Ikôn Rugged PDA (Windows Mobile 6.1) User Manual
7.6.5 Troubleshooting
7.6.5.1 Ikôn Charge Indicator LED Stays Off
When an Ikôn is docked into a powered CH4004 and its charge indicator LED stays off,
there could be a problem with the Ikôn or with the docking station. Use an Ikôn with a prop-
erly functioning charge indicator to isolate the problem.
7.6.5.2 Ikôn Charge Indicator LED Fast Flashes Green
If the Ikôn charge indicator fast flashes green when the Ikôn is in any of the four sites:
Remove the Ikôns and disconnect the adaptor DC power cable.
Wait at least 20 seconds, and then plug the cable in again.
If the Ikôn indicator still shows a fault, the Ikôn requires service.
7.6.5.3 Green LED OFF When Connected To A Network
Check the Category 5/5e cable. Replace if the cable is suspect.
Contact your network administrator.
7.6.5.4 Yellow LED OFF When Connected To A 100Base-T Network
Check the Ethernet cable. Replace if the cable is suspect.
Contact your network administrator to ensure the network is running at 100 Mbps.
7.6.5.5 Powered Adaptor LED Stays Off
Check the AC cable. Replace with the same type if the cable is suspect.
If the adaptor's LED stays OFF, the adaptor is defective and requires service.
7.7 AC Wall Adaptor – Model No. PS1050-G1
The AC wall adaptor available for your Ikôn allows you to operate your Ikôn using AC
power while charging the battery inserted in the unit.
Adaptor plugs suitable for use in the following countries are shipped with the AC wall adap-
tor: United Kingdom, Switzerland, Japan, Israel, Australia, Europe, and North America (see
Figure 7.7 on page 263).