3.9
Owner's of the ProForm Hot Tub PFSG51030 gave it a score of 3.9 out of 5. Here's how the scores stacked up:
12
Using the Controls
Refer to the diagram above. The function of each
control is explained below:
Pump Button: Turns the spa jets on and off. If the
button is pressed once, the spa jets will run at low
speed, providing gentle hydrotherapy. If the button is
pressed again, the jets will run at high speed, provid-
ing more intense hydrotherapy. If the button is
pressed a third time, the jets will shut off.
The spa also features an automatic mode that heats
and filters the water when the spa is left unattended.
When the spa is first plugged in, or if the buttons on
the console have not been pressed for longer than
twenty minutes, the automatic mode will begin filtering
or heating the water as needed. Note: To keep the
filter and heat cycles from running, the power
cord must be unplugged.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting
of the water. The temperature can be set from 80°F to
104°F. The water heats at about 1.8°F per hour with
the cover on. Use a medical or other accurate ther-
mometer to check the temperature of the water. Note:
The word “COOL” will appear in the console display if
the temperature of the water is more than 20°F cooler
than the set temperature. When this happens, the
heater will automatically activate to warm the water.
The word “ICE” will appear in the display if the tem-
perature drops below 40°F. If this happens, the pump
will automatically circulate the water and warm the
plumbing to keep the water from freezing.
The temperature buttons can also be used to change
the filter cycle time. First, press either of the tempera-
ture buttons. While the console display is flashing,
press the jet button. The letters “FC” should appear in
the display. Next, press the temperature buttons to
select a 2-, 4-, or 6-hour filter cycle time. Then, press
the jet button again. If the filter cycle time is not
changed, it will default to 2 hours.
Air Controls: Determine the amount of air flowing
through the hydrotherapy jets during operation. If a
control is turned counterclockwise, the amount of air
flowing through the jets will increase. If the control is
turned clockwise, the amount of air will decrease.
Light
Button
Pump
Button
Display
Temperature
Buttons
Find Your Products By Category
Please Login
