0
Owner's of the ProForm Home Gym PFEX31420 gave it a score of 0 out of 5. Here's how the scores stacked up:
5
2. Hold the Upright (2) in the location shown. Connect
the Extension Wire (66) to the Wire Harness (22).
Attach the Upright to the Frame (1) with four M6 x
12.7mm Button Screws (62), four M6 Split Washers
(57), and four M6 Flat Washers (67). Make sure
that the Extension Wire and the Wire Harness
are not pinched.
Slide the Collar (48) onto the Upright (2). Align the
slit in the Collar with the seam between the Side
Shields (4, 5). Snap the Collar into the Side Shields.
2
22
1
4
5
57
67
2
48
Seam
62
57
66
67
3. The Console (3) requires four “D” batteries (not
included); alkaline batteries are recommended.
Press the tab on the battery cover, and lift off the
battery cover. Insert four batteries into the battery
compartment. Make sure that the batteries are ori-
ented as shown by the diagram inside the bat-
tery compartment. Reattach the battery cover.
3
Tab
Batteries
Battery
Cover
3
44
Metal
Tube
4. Connect the wire harness on the Pulse Sensor (44)
to the indicated wire harness on the Console (3).
Insert both wire harnesses into the opening in the
bottom of the Console. Then, insert the metal tube
on the Pulse Sensor into the opening in the bottom
of the Console. Be careful not to pinch the wire
harnesses.
Refer to the inset drawing. Tighten an M4 x 16mm
Screw (64) into the indicated bracket on the Console
(3) and into the metal tube on the Pulse Sensor (44).
Snap the bookrack onto the Console (3) in the indicat-
ed location.
4
3
Bookrack
Wire Harnesses
64
64
3
44
5. Hold the Console (3) near the Upright (2). Connect
the console wire to the Extension Wire (66). Attach
the Console to the Upright with three M10 x 25mm
Button Screws (81) and three M10 Split Washers
(46). Make sure that the console wire and the
Extension Wire are not pinched.
5
81
3
Console
Wire
66
46
46
81
2
Find Your Products By Category
Please Login
