3.9
Owner's of the iHome Clock Radio iH36 gave it a score of 3.9 out of 5. Here's how the scores stacked up:
13
Maintenance
• Place the unit away from sources of direct sunlight or excessive heat.
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine,
thinner or similar materials can mar the surface of the case.
Setting Up
This unit has a Clock which is preset at the factory. It takes just a few steps to match the clock setting to where you live.
1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the ¹ DST Switch located
on the bottom of the unit to +1 or -1 to adjust the time forward or backward one hour.
2. Press and hold the Ƹ Time Zone Button located on the bottom of the unit for approx. 2 seconds until the Time Zone
Indicator at the lower part of the display shows the current time zone and flashes. Press the ᕦ Select Up/FF or
ᕥ Select Down/Rew Buttons to select the time zone.
3. Press the Ƹ Time Zone Button again to (or if no key pressed for approx. 10 seconds) exit the setting mode.
4. If the time showing is not correct, please see Setting Time and Calendar to set the clock.
Note: You can adjust the contrast of the display by pressing and holding the Ƹ Time Zone Button until the zone display
flashes, and then pressing the Preset 1 or Preset 2 button to achieve the preferred contrast.
Setting Time and Calendar
1. Press and hold the ¸ Clock Adj Button located on the bottom of the unit for 2 seconds until the year is flashing in the
display. Press the button again to accept the current setting or press the ᕦ Select Up or ᕥ Select Down Button until
the current year is displayed. Press the ¸ Clock Adj Button to confirm year setting after adjustment.
2. The display will change to show the date flashing. Press the ¸ Clock Adj Button to accept the current setting or press
the ᕦ Select Up or ᕥ Select Down Button until the current date is displayed. Holding the button for a few seconds
will advance or reverse rapidly. Press the ¸ Clock Adj Button to confirm date setting after adjustment.
3. The time on the upper part of display will flash. Press the ᕦ Select Up or ᕥ Select Down Button until the current time
is displayed.
Holding the button for a few seconds will advance or reverse rapidly. Remember to set the correct AM or PM.
4. Press the ¸ Clock Adj Button again to (or if no key pressed for approx. 10 seconds) exit the setting mode.
Charging your iPod
Note: Please make sure you are using the correct insert for your iPod (see Install iPod Insert on page 10) and that it is
properly docked into the iH36. Failure to do so may damage your iPod.
1. Press the ᕣ Dock Open/Close Button to open the iPod dock then dock your iPod into it.
2. While your iPod is docked in the system, it recharges (until fully charged).
3. Press the ᕣ Dock Open/Close Button again to close the dock. The iPod will recharge whether the dock is open or not.
4. For iPod Shuffle, just plug it into the shuffle connector located on the bottom of the unit. The iPod Shuffle will keep
charging until fully charged.
Find Your Products By Category
Please Login
