0

Out of 0 Ratings

Owner's of the Garmin GPS Receiver GPSMAP gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 82
 
GPSMAP 400/500 Series Owner’s Manual 43
Conguring the Chartplotter
Setting the Total Fuel Onboard Alarm
You can congure your chartplotter to sound an alarm when the total
amount of remaining onboard fuel reaches the specied level.
To receive fuel-level information, your unit must be connected to an
external fuel sensor, such as the Garmin GFS 10.
To enable the Total Fuel Onboard alarm and set the fuel
alarm level:
1. From the Home screen, select Congure > Alarms > Fuel >
Total Onboard > On (or Off).
2. If you select On, use the Rocker to indicate the fuel level at
which the alarm should sound.
Conguring My Boat
To congure settings for your boat, from the Home screen, select
Congure > My Boat.
Keel Offset
—offset the surface reading for the depth of a keel,
making it possible to measure depth from the bottom of the keel
instead of from the transducer location. Enter a positive number to
offset for a keel. Enter a negative number to compensate for a large
vessel that may draw several feet of water.
To adjust the Keel Offset:
1. From the Home screen, select Congure > My Boat > Keel
Offset.
2. Use the
Rocker to enter the measured distance from the
transducer location to the water line or to the keel of the boat.
If you are measuring down to the keel (transducer installed at
the water line), enter a (+) positive number. This shows the
depth at the bottom of the keel.
If you are measuring up to the water line (transducer installed
on the bottom of the keel), enter a (-) negative number. This
shows the depth at the surface.
3. Select Done to accept the number.
A (+) positive number
shows depth at the bottom
of the keel.
Transducer at Surface
A (-) negative number
shows depth at the
surface.
Transducer at the
Bottom of the Keel
Temp Offset—set the temperature offset for the temperature sensor
of your transducer.