PYLE Audio Car Speaker 10" SUPER SLIM ACTIVE SUBWOOFER User Manual

0

Out of 0 Ratings

Owner's of the PYLE Audio Car Speaker 10" SUPER SLIM ACTIVE SUBWOOFER gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 4
 
Front
panel
controls
and
features
CD
POWER
ON
LED
INDICATOR
® PHASE SHIFT
Use this switch to help compensate for time alignment problems
in
the
system. Such problems usually result from having the subwoofer at a
different distance from the listener than the other speakers
in
the system.
@ INPUT GAIN CONTROL
After you have installed your system, turn this control to minimum.
Tum the head unit
on
(and the subwoofer will tum
on
via the remote
connection). Turn the head unit volume to about
2/3
full level.
Slowly turn up the subwoofer input gain control until you hear a small
amount
of
distortion. Then reduce the level until the distortion is
completely
gone.
Leave the control at this setting.
@BASSBOOST
The bass boost feature will increase the sound level the bass frequencies.
® LOW PASS FILTTER
This control permits you define the frequency range you want the subwoofer
amplifier to receive. The subwoofer will reproduce all sound BELOW the
frequency you set.
If the rest
of
your system is weak on the mids , you may wish to set this
control relatively high. If the midrange is well covered by the rest
of
your
system, you will probably want the subwoofer to only receive lower
frequency signal.
® REMOTE LEVEL CONTROL PORT
Attach the included remote level control to control the volume level
of
the
subwoofer independently.
(j)
PROTECT
LED
INDICATOR
3-PLBASS10
Owner's
Manual
Rear
panel
controls
and
features
CD
LOW
LEVEL
RCA
INPUTS
Low level inputs are the recommended
way
to introduce the audio signal
to the subwoofer
if
RCA
outputs are present on
your
head unit
or
other
signal source (such
as
a sound processor).
® HIGH
LEVEL
(speaker
level)
INPUTS
If
your
head unit does
not
have RCA
outputs,
you can use the speaker
outputs for the audio source for the PLBASS10. Use the supplied cable
and connect the outputs properly
as
shown in the connection diagram
in this
manual.
@FUSE
The
fuse is rated
at
20A.
Do
not
use a fuse with a different value and
NEVER
replace the fuse with a wire
or
coin.
@
POWER
TERMINALS
PLBASS10
Owner's
Manual-4

   Find Your Products By Category