PYLE Audio Car Amplifier PYLE Hydra Series User Manual

0

Out of 0 Ratings

Owner's of the PYLE Audio Car Amplifier PYLE Hydra Series gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 8
 
4
5
features and specifications
6 ch amp PLMRA620
frequency response
power supply voltage
output power @ 14.4v DC, 1KHz
RMS Power @ 4 Ohms
RMS Power @ 2 Ohms
Maximum Power Output
input sensitivity
low level inputs
maximum current draw
dimensions (W x H x L)
mm
inches
input impedance
low level inputs
high level inputs
matching speaker impedance
stereo mode
bridged mode
CH3/CH4 crossover mode selector
input level control
CH5/CH6 low pass frequency control
CH1/CH2/CH3/CH4
high pass frequency control
bass boost level control
low level inputs
power LED
protection LED
power fuse
power terminals
speaker connections
when used with normal, full range systems, set this switch to “FULL.” If you wish to
use the internal crossover to power a driver of specific frequency range, use the
“LOWPASS” or “HIGHPASS” settings.
use this control to match the outputs of your head unit to the amplifier. Starting with
your head unit set at about the 2 o’clock position, increase the amp level control until
distortion begins to occur, and reduce slightly from this point.
when the crossover selector switch is in “low pass” mode, this control sets the upper
frequency limit for audio program sent to the speakers.
when the crossover selector switch is in “high pass” mode, this control sets the lower
frequency limit for audio program sent to the speakers.
this control permits adjustment of the bass level up to an increase of approximately
18 dB.
this amp features gold-plated RCA input jacks for high impedance input. Use these
with car stereo output which uses RCA-type connector cables.
this indicator is illuminated when power is applied.
this indicator is illuminated when built-in protection circuitry is activated.
the fuse protects the amplifier and your car’s electrical system from short circuit
conditions.
use these connectors to deliver power, ground and remote turn-on control to the
amplifier.
these terminals are 14K gold plated to guarantee high conductivity and minimum
signal loss.
PLMRA620
6 channel amplifier
4 x 100 Watts + 2 x 250 Watts
4 x 175 Watts + 1 x 400 Watts
4 x 250 Watts + 2 x 500 Watts
15 Hz-30 KHz
250mV
14.4V DC Neg. Ground (10.5-16V)
2-4 Ohms
30A x 2
4-8 Ohms
10K Ohms
100 Ohms
276 x 69.5 x 498
10.9 x 2.7 x 19.6
electrical connections
6 ch amps PLMRA620
PLMRA620

   Find Your Products By Category