ProForm Hot Tub PFSW73900, PFSB73900, PFSG73900 User Manual

2.1

Out of 2 Ratings

Owner's of the ProForm Hot Tub PFSW73900, PFSB73900, PFSG73900 gave it a score of 2.1 out of 5. Here's how the scores stacked up:

  • Reliability

    2.0 out of 5

  • Durability

    2.0 out of 5

  • Maintenance

    2.0 out of 5

  • Performance

    2.5 out of 5

  • Ease of Use

    2.0 out of 5
of 20
 
9
5. After a qualified electrician has wired the spa to a
240 volt power source, refer to the inset drawing. Lift
the filter cover (see assembly drawing 1) and insert
the Filter (15), the Basket (4), and the Round Weir
(3) into the filter housing.
Remove the two warning decals (not shown) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service it. Once the spa is filled, it will
have to be drained before it can be moved.
See the inset drawing. Insert a garden hose or other
clean water source into the filter housing. Fill the spa
until the water level reaches the line directly below
the decorative tile. Do not overfill the spa. Do not
use soft water. The spa may be filled with cold
water; however, if warm or hot water is used, the spa
will be ready for use sooner. Replace the filter cover
(see assembly drawing 1).
3. Make sure that the three indicated collars are tight-
ened.
Refer to step 1. Re-attach the Access Panel (5) to
the spa.
4. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 240 volt Ground
Fault Circuit Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified,
licensed electrician. A wiring diagram is found on the inside of the electronics package for reference.
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before
you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed.
6. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (26) against one of the premium
cedar panels on the spa. (Note: To position the
Buckle correctly, have a second person hold the
strap on the opposite side of the Spa Cover snug.)
The Spa Cover must be snug. Do not place the
Buckle over the grooves between the premium
cedar panels. Refer to the inset drawing. Remove
the latch from the Buckle (26). Attach the Buckle to
the premium cedar panel with two #4 x 3/4” Screws
(27).
Attach the other three Buckles (26) to the premium
cedar panels in the same way.
Remove the Spa Cover (11) from the spa.
5
3
Fill to Here
Garden Hose
Filter
Housing
Collar
Collar
Electronics Package
Gate
Valve
6
11
26
Strap
Strap
Latch
26
27
4
3
15
Filter
Housing

   Find Your Products By Category