3.3
Owner's of the ProForm Elliptical Trainer R-930 gave it a score of 3.3 out of 5. Here's how the scores stacked up:
MAINTENANCE AND STORAGE
Inspect and tighten all parts of the R-930 regularly.
Clean the R-930 periodically with a soft, damp cloth.
To prevent damage to the console, keep liquids away
from the console and keep the console out of direct
sunlight.
HOW TO LUBRICATE THE R-930
Every three
months, a
small amount
of light multi-
purpose oil
should be
applied to the
R-930. Apply a
few drops of
oil between
the dome caps
ppl Oil
and the fr_a.me In the locations shown at the dght. Be
sure to apply oil to both sides of the R-930.
HOW TO ADJUST THE REED SWITCH
If the console does not operate propedy, the battedes
should be replaced. See assembly step 3 on page 4.
for installation instructions.
If the console
• does not dis-
play correct
feedback, the
position of the
Reed Switch
(33) should be
adjusted.
Loosen, but do
not remove,
the two indi-
cated #8 x 1/2=Screws (35). Slide the Screws t/8" tO
the left or dght, making sure to keep the upper ScreWy
directly above the lower Screw. Make sure that the
lever on the Reed Switch is bt_hlnd the indicated
tab. Tighten the Screws. Exercise on the R-930 for a
moment. Repeat until the console displays correct
feedback.
HOW TO STORE THE R-930
When the F_-930 is not in use, it can be folded for
compact storage. Follow the steps st the dght to fold
the R-930. Note: If_he seat is near the rear of the
seat frame, the R-930 cannot be folded. If necessary,
move the seat forward before folding the R-930 (see
HOW TO ADJUST THE SEAT on page 5).
1. Hold the Handlebar (4) firmly and pivot it back and
down until the Wheel (26) hits the stop tab. Next,
liftthe Seat (7) slightlyand continue to pivot the
Handlebar down until the R-930 is in the position
shown in drawing la. Fold down the Console (13).
Stop Tab
26
2. If desired, the R-g30
can be stored in a 2
vertical position.
Fold the R-930 as"
described above.
Next, firmly hold
the Handlebar (4)
with one hand, and
hold the rear tube
of the Frame (1)
with the other
hand. Raise the R-
930 to the position
shown at the dght.
Make sure that the
!:1-930is resting on
a level surface, and
that the slda with
the crossbar is
against a wall for
stabllity.
To set up the R-930 for use, follow the steps above in
reverse order. When lowering the R-930 from the
vertical storage position, remember to hold both
the handlebar and the rear tube of the frame.
7
Find Your Products By Category
Please Login
