4.0

Out of 1 Ratings

Owner's of the iHome Clock Radio iP47 gave it a score of 4.0 out of 5. Here's how the scores stacked up:
  • Reliability

    4.0 out of 5
  • Durability

    4.0 out of 5
  • Maintenance

    4.0 out of 5
  • Performance

    4.0 out of 5
  • Ease of Use

    4.0 out of 5
of 20
 
10
Replacing the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduces, it is time to replace a new one.
1. The battery door is located on the back end of the unit.
2. Pull the battery door to release the battery door latch and take out the battery holder.
3. Insert a CR2032 battery, checking the + and – ends of the battery is matching to the
drawing inside the battery compartment.
4. Replace the battery holder back into the remote control.
Note: Make sure you dispose of batteries properly (see your local regulations).
For best results, aim remote control towards the remote sensor on the lower center of the
unit.
Battery Door
Install Clock Backup Battery
The iP47 uses 3 x AA backup battery system to provide backup
alarm operation and clock settings in the event of a power failure. If
the Backup Battery has been installed and a power failure occurs or
the AC cord is accidentally disconnected, the display backlight will
not remain lit, but current time and alarm time settings will be
temporarily maintained. Otherwise, you must reset the time and
alarm settings.
1. Open backup battery compartment door located on the bottom of
the unit.
2. Please make sure the AC adaptor is connected. Otherwise all
settings may be lost during battery replacement.
3. Insert 3 AA batteries, checking that the polarity (+ and – ends of
the battery) matches the drawing near the battery compartment.
Close the compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).
Replace Backup Battery