iHome Clock Radio IP43 User Manual

4.6

Out of 3 Ratings

Owner's of the iHome Clock Radio IP43 gave it a score of 4.6 out of 5. Here's how the scores stacked up:

  • Reliability

    4.67 out of 5

  • Durability

    4.33 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    4.5 out of 5

  • Ease of Use

    4.33 out of 5
of 14
 
8
Sleep mode, Dimmer and more
Sleep Operation
Sleep mode lets you sleep to your iPhone/Pod or radio, gradually lowering the volume until the unit shuts off at the selected
time.
1. Press the Sleep Button to enter sleep mode. The sleep time will show in the lower display.
2. Press the Sleep Button again as needed to adjust the sleep timer from 120, 90, 60, 30 or 15 minutes.
3. When the display changes back to show the real time, press the Sleep Button once to show the sleep time remaining.
Pressing it again will change sleep time to next lowest increment.
4. iP43 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the normal
volume. The sleep volume will remain at that level the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the Button to turn unit off.
Dimmer Operation
During normal operation, press the Snooze/Dimmer Button to control the brightness of the LCD display.
Using the iP43 in Other Countries
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches
the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US,
you may skip this section.
1. Make sure the iP43 is OFF (not playing in any mode). Press and hold the Radio Button for about 5 seconds until “USA”
appears in the lower part of display. Turn the Set Wheel to adjust country frequency to your region.
2. Press the Radio Button again (or no button within 5 seconds) to exit the radio frequency setting mode.
To memorize a station as a preset
1. In Radio mode, turn the Set Wheel to select a station.
2. Press and hold the desired Preset Button until the odd number preset (P1, P3, P5) flashes on the display; press again to
assign the station to the related even number preset (P2, P4, P6). Allow to time-out. You will hear a beep confirming the
preset has been assigned. To change presets, repeat steps 1 and 2.
To access a preset station
1. At any time, press the desired Preset Button once to listen to odd number presets or twice for even number presets.

   Find Your Products By Category