0

Out of 0 Ratings

Owner's of the Garmin Marine GPS System GPSMAP gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 100
 
GPSMAP 700 Series Owner’s Manual 39
Almanac, On-boat, and Environmental Data
Setting Description
Scale minimum This value is less than the rated minimum, and it represents the lower limit of the gauge.
This setting is not available on all gauges.
Scale maximum This value is greater than the rated maximum, and it represents the upper limit of the
gauge. This setting is not available on all gauges.
Rated minimum Represents the minimum value of the standard operating range.
Rated maximum Represents the maximum value of the standard operating range.
1. From the Home screen, select  >  >  >  >  >
.
2. Select a gauge.
3. Select  >  > .
4. Select the gauge limit you want to set (, , , or ).
 Some of these options may not be available for all gauges.
5. Select the gauge limit.
6. Repeat steps 4 and 5 to set additional gauge limits.
Activating Status Alarms for Engine Gauges and Fuel Gauges
If you have activated gauge status alarms, when the engine sends a warning status message over the NMEA
2000 network, a gauge status alarm message appears. The gauge face or bar may become red depending on the
alarm type.
From the Home screen, select  >  >  >  >  >
 >.
Customizing Engine and Fuel Gauge Status Alarms
1. From the Home screen, select  >  >  >  >  >
 >.
2. Select one or more engine gauge or fuel gauge alarms that you want to turn on or off.
3. Select .
Selecting the Number of Engines Shown in Gauges
The engine gauges can show information for up to four engines.
1. From the Home screen, select  >  >  >  >  >
 > .
2. Select the number of engines.
3. Complete an action:
Select .
Select  and complete steps 2 through 5 of “Selecting the Engines Shown in Gauges”
(page 39) to select the engines for which information appears in the gauges.
Selecting the Engines Shown in Gauges
You must manually select the number of engines shown in the engine gauges (page 39) before you can select
the engines for which information appears in the gauges.
1. From the Home screen, select  >  >  >  >  >
 > .
2. Select .
3. Select the number of the engine for which you want to view information in the rst gauge or bar.
For example, if you select “3,” the rst engine bar shows information for the engine identied as
“Engine3” on the NMEA 2000 network.
4. Repeat step 3 for the second, third, and fourth engine bar, as needed.
5. Select .