Garmin GPS Receiver nüvi User Manual

5.0

Out of 1 Ratings

Owner's of the Garmin GPS Receiver nüvi gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 112
 
RAIM not available - The GNC 250 is unable to cross-check its
position using RAIM. You may continue to
navigate using visual flight rules. Your posi-
tion should be verified every 15 minutes
using other navigation sources. If you have
selected a CDI scale other than ‘Auto’, select-
ing a larger CDI scale may remove the condi-
tions causing this message.
RAIM position warn - RAIM has detected position errors. If you
have selected a CDI scale other than ‘Auto’,
selecting a larger CDI scale may remove the
conditions causing this message.
RAM failed - The GNC 250 has detected a failure in its
internal memory. If the message persists, the
GNC 250 is unusable and should be taken to
an authorized GARMIN service center.
Rcvr needs service - The GNC 250 has detected a condition
requiring service in the receiver hardware.
The GNC 250 should be taken to an autho-
rized GARMIN service center.
Ready for navigation - The GNC 250 is ready for navigation.
Received invalid wpt - A waypoint was received in an upload opera-
tion that has an invalid identifier or position.
Receiver failed - The GNC 250 has detected a failure in the
receiver hardware. If the message persists, the
GNC 250 is unusable and should be taken to
an authorized GARMIN service center.
Remote ENT key stuck - The remote ENT key is stuck in the ‘pressed’
state. Check the installation.
Remote XFR key stuck - The remote XFR key is stuck in the ‘pressed’
state. Check the installation.
ROM failed - The GNC 250 has detected a failure in its
permanent memory. If this message occurs,
the unit is unusable and should be taken to
an authorized GARMIN service center.
Route is empty - An attempt has been made to activate an
empty route.
Route is full - An attempt has been made to add more than
31 waypoints to a route. The GNC 250 will
not allow more than 31 waypoints per route.
Route wpt deleted - One or more route waypoints were deleted
while receiving data from the optional PC150
Interface Kit.
Route wpt locked - At least one route waypoint is locked because
the waypoint has been removed from the
Jeppesen NavData®, the data card is missing,
or the data card has failed.
Route wpt moved - One or more route waypoints were moved at
least 0.33 arc minutes due to a database
change.
89
SECTION
D
MESSAGES &
ABBREVIATIONS
250 real 7/14/98 9:33 AM Page 89

   Find Your Products By Category